Plastic HDPE Extrusion Blow Molding Machine 5 Liter Two Years Warranty

Plastic HDPE extrusion blow molding machine 5L for plastic model

Introduction

In blow molding, hollow plastic parts are being formed through a manufacturing process that is generally categorized into three main methods, namely injection blow molding, extrusion blow molding and injection stretch blow molding. Basically, the extrusion blow molding starts with melting down the plastic and forming it into a parison—a rounded mass of molten material formed by rolling it immediately after being removed from the furnace, with its final form being a tube-like plastic that has a hole in one end that serves as a passage way for compressed air. This material is then clamped into a mold and then blown by air, of which pressure will push the plastic out in order to match the mold. Once it has cooled and hardened, the mold would open up to eject the part. In the case of injection and injection stretch blow molding, these processes use a preform, which is a piece that already has a form beforehand.

Now, many plastic manufacturers use this method for the obvious benefits it brings. However, there are also some drawbacks to it that we should be aware of to know whether it is best to employ for the betterment of all.

1. Control Unit: Japan Mitsubishi PLC programmable controller and Taiwan HITECH touch panel. English parameter process setting, state monitoring and products counting are convenient and intuitionistic. PLC automatic temperature control model.

2. Hydraulic Unit: It adopts international famous Japan YUKEN brand hydraulic valve and seal, proportional control. And has features of high stationarity and reliability, accurate operation, long longevity, quick response and so on.

3. Extrusion Unit: Hard gear surface decelerator; famous HFinverter inverter adopts Italian technology; Screw speed regulation adopts variable-frequency speed regulation control system. It has the features of stable rotate speed, powerful power, energy-saving and so on. Mixing screw has wide applicability to raw materials and the plasticization quality is even better. Energy-saving machine barrel and A-alloy heaters are adopted for heating.

4. Die Head Unit: With single cylinder material-center-in accumulator head, is smooth and dependable. This die head adopts German technology and is made by special imported steel.

5. Clamping Unit: Adopts fixed mould open-closing system,fast and balanced.

6. Blow Fitting Unit: Down blowing fitting is equipped.

7. Lifter Unit: Four turbine reducer liter, lifting balance, quick, stable.

8. Electrical Components: All of the electrical components are made in Japan and Taiwan.

Parameter

Company Introduction

ZHANGJIAGANG U TECH MACHINE was founded at 2008.It is located at Zhangjiagang city economic industrial town,We devote ourselves to the development, research and production of extrusion blow molding machine Our Main products including: extrusion blow molding machine ,leak tester,bottle neck cutting machine ,cap liner,bagger packing machine and many kinds of labeling machine. All the products are sold well in every province and city of the whole country and also exported to about thirty countries and areas with strong technical force, advanced equipment, scientific management system and perfect after-sales service.

Company culture